Eureka 5740-5799 Series 用户手册

Brush Roll

The brush roll turns as it sweeps and combs the carpet nap.

Remove hair and threads from the brush roll so it continues

brushing the carpet. To maintain the most efﬁcient cleaning,

the bristles must touch the carpet. To test the bristle length,

hold a ruler against the underneath side of the cleaner. If the

bristles no longer touch the ruler, replace the brush roll.

Brush Roll Belt, Style U

The brush roll belt turns the brush roll to agitate, sweep, and

comb the carpet nap. Check the belt regularly to be sure it is

in good condition. Replace the belt if it stretches, cracks or

loses tension. Cut away any hair or threads wound around

the brush roll or the belt pulley because the buildup could

cause the belt to rotate unevenly.

How To Replace Brush Roll Belt

NOTE: Turn off the switch and unplug the electrical

cord before replacing belt. Belt pulleys can

become hot during normal use. To prevent

injury, avoid touching the motor shaft when

changing the belt.

PERIODIC MAINTENANCE

(CONTINUED)

1. Lower handle to ﬂoor to change belt.
2. Remove three screws indicated by screwdrivers in above

illustration. Lift hood to remove.

NOTE: The carpet height adjustment has to be in

the lowest or highest position to remove or

reinstall the hood.

3. Lift right end of brush roll.
4. Remove and discard belt.

Brush

Roll

Belt

Motor

Shaft

5. Place new belt around motor shaft.

6. Place belt around brush roll pulley.
7. Align left end cap with base. Push end cap securely into

place. Be sure square on end of brushroll is securely in

place.

8. Pull right side of brush roll to stretch belt. Secure right end

cap into base.

IMPORTANT

Rotate brush roll by hand two full rotations

to properly position belt.

10. Place hood back on cleaner. Make sure hood front is

behind furniture guard. Replace three screws.

11. Tighten screws.

Use GENUINE EUREKA replacement belt, Style U. Look

for the GENUINE EUREKA product symbol.