AMX HDMI-UTPRO-0808 用户手册
HDMI-UTPRO-RX NetLinx Programming
94
Instruction Manual – HDMI-UTPRO-0808
HDMI-UTPRO-RX IR SEND_COMMANDs (continued)
CTOF
Set the duration of the Off
time (no signal) between IR
pulses for channel and IR
function transmissions. Off
time settings are stored in
non-volatile memory.
Set the duration of the Off
time (no signal) between IR
pulses for channel and IR
function transmissions. Off
time settings are stored in
non-volatile memory.
This command sets the delay time between pulses generated by the 'CH' or 'XCH' send
commands in tenths of seconds.
Syntax:
commands in tenths of seconds.
Syntax:
SEND_COMMAND <DEV>,"'CTOF',<time>"
Variables:
• time = 0 - 255. Given in 1/10th of a second increments. Default is 5 (0.5 seconds).
Example:
• time = 0 - 255. Given in 1/10th of a second increments. Default is 5 (0.5 seconds).
Example:
SEND_COMMAND dvRXIR,"'CTOF',10"
Sets the off time between each IR pulse to 1 second.
CTON
Set the total time of IR
pulses transmitted and is
stored in non-volatile
memory.
Set the total time of IR
pulses transmitted and is
stored in non-volatile
memory.
This command sets the pulse length for each pulse generated by the 'CH' or 'XCH' send
commands in tenth of a second increments.
Syntax:
commands in tenth of a second increments.
Syntax:
SEND_COMMAND <DEV>,"'CTON',<time>"
Variables:
• time = 0 - 255. Given in 1/10th of a second increments. Default is 5 (0.5 seconds).
Example:
• time = 0 - 255. Given in 1/10th of a second increments. Default is 5 (0.5 seconds).
Example:
SEND_COMMAND dvRXIR,"'CTON',20"
Sets the IR pulse duration to 2 seconds.
IROFF
Halt and Clear all active or
buffered IR commands
being output on the
designated port.
Halt and Clear all active or
buffered IR commands
being output on the
designated port.
Syntax:
SEND_COMMAND <DEV>,"'IROFF'"
Example:
SEND_COMMAND dvRXIR,"'IROFF'"
Immediately halts and clears all IR output signals on the IR port.
SP
Generate a single IR pulse.
Generate a single IR pulse.
You can use the 'CTON' to set pulse lengths and the 'CTOF' to set time Off between pulses.
Syntax:
Syntax:
SEND_COMMAND <DEV>,"'SP',<code>"
Variables:
• code = IR code value 1 - 96.
Example:
• code = IR code value 1 - 96.
Example:
SEND_COMMAND dvRXIR,"'SP',25"
Pulses IR code 25 on IR port on RX.
XCH
Transmit the selected
channel IR codes in the
format/pattern set by the
'XCHM' Send Command.
Transmit the selected
channel IR codes in the
format/pattern set by the
'XCHM' Send Command.
Syntax:
SEND_COMMAND <DEV>,"'XCH <channel>'"
Variables:
• channel = 0 - 999.
Example:
• channel = 0 - 999.
Example:
For detailed usage examples, refer to the 'XCHM' command (next in table).