Yamaha RX-A2010 用户手册

En

■ 

Connect the speakers placed in your room to this unit. 

If you have 9 speakers, use two of them as surround back speakers (*1) or rear 
presence speakers (*2). If you have 7 speakers, use two of them as surround back 
speakers (*3) or front presence speakers (*4).

• You can also connect up to 2 subwoofers (with built-in amplifier) to this unit. When using 2 subwoofers, 

configure the “SWFR Layout” setting (p.111) in the “Setup” menu after connecting the power cable to an AC 
wall outlet.

• To use an external power amplifier (Hi-Fi amplifier, etc.) to enhance speaker output, see “Connecting an 

Speaker cables (x the number of speakers)

Audio pin cable (2 for connecting 2 subwoofers)

Connection diagram
Refer to the following diagram and connect the speakers to this unit.

• When using only one surround back speaker, connect it to the SINGLE jack (L side).

• Remove the power cable of this unit from an AC wall outlet and turn off the subwoofer before 

connecting the speakers.

• Be careful that the core of the speaker cable does not touch anything or come into contact with the 

metal areas of this unit. This may damage this unit or the speakers. If the speaker cables short circuit, 
“CHECK SP WIRES” will appear on the front display when this unit is turned on.

Main zone

Front (L)

●

●

●

●

●

Basic (default)

Front (R)

●

●

●

●

●

Center 

●

●

●

●

Surround (L)

●

●

●

●

Surround (R)

●

●

●

●

Surround back (L)

●

{*1

{*3

Surround back (R)

●

{*1

{*3

Front presence (L)

●

●

{*4

Front presence (R)

●

●

{*4

Rear presence (L)

●

{*2

Rear presence (R)

●

{*2

–

+

–

+

This unit (rear)