JVC RX-D412B 用户手册
1
Turn on the power
Press
STANDBY/ON (or
AUDIO on the
remote control).
The standby lamp goes off and the current source lamp lights
in red.
in red.
To turn off the power (into standby):
Press
Press
STANDBY/ON (or
AUDIO on the remote control)
again.
The standby lamp lights in red.
The standby lamp lights in red.
NOTES
• A small amount of power is consumed in standby mode. To turn the
power off completely, unplug the AC power cord.
• Turning a source component on before turning the receiver on
may cause a noise or interrupt the sound and picture. In this case,
turn both the source component and the receiver off, then turn the
receiver on before turning the source component on.
turn both the source component and the receiver off, then turn the
receiver on before turning the source component on.
Basic operations
Source lamps
Current source name appears.
2
Select the source to play
On the front panel:
Turn SOURCE SELECTOR until the source
name you want appears on the display.
name you want appears on the display.
The source lamp corresponding to the selected source lights
in red.
• As you turn SOURCE SELECTOR, the source changes as
in red.
• As you turn SOURCE SELECTOR, the source changes as
follows:
DVR/DVD:
Select this for the DVD recorder or DVD player.
VCR:
Select this for the VCR.
DBS:
Select this for the DBS tuner.
TV*:
Select this for the TV.
SIRIUS*:
Select this for the SIRIUS Satellite Radio.
USB:
Select this for the PC component.
XM:
Select this for the XM Satellite Radio.
FM:
Select this for the FM broadcast.
AM:
Select this for the AM broadcast.
From the remote control:
Press one of the source selecting buttons.
• For “FM” and “AM,” press FM/AM.
Each time you press the button, the band alternates
between “FM” and “AM.”
between “FM” and “AM.”
NOTE
When you connect a VCR or DBS to the HDMI VCR(DBS) IN terminal
or COMPONENT VIDEO jacks on the rear of the receiver, you need
to select either “VCR” or “DBS” for each terminal according to the
component you connect (see page 34).
or COMPONENT VIDEO jacks on the rear of the receiver, you need
to select either “VCR” or “DBS” for each terminal according to the
component you connect (see page 34).
* Changing the source name of TV/SIRIUS input
On the front panel ONLY:
Press SET when “TV” is selected as the
source.
source.
• “ASSIGN SIRIUS” appears on the display for a while.
• To change the source name to “TV,” press SET when “SIRIUS”
is selected as the source. “ASSIGN TV” appears on the display
for a while.
for a while.
DVR/DVD
Ô VCR Ô DBS Ô TV(SIRIUS)* Ô USB Ô
XM
Ô FM Ô AM Ô (Back to the beginning)
1
3
2
1
2
2
3
20
20-23_BasicOP.indd 20
20-23_BasicOP.indd 20
06.5.19 1:13:54 PM
06.5.19 1:13:54 PM