JVC RX-D412B 用户手册

When you use the digital input terminals, register what 
components are connected to which terminals—DIGITAL 
IN 1/2/3 (see page 14) so that the correct source name will 
appear when you select the digital source.
Select one of the following components for each terminal:

For the DVD player (or DVD recorder)

For the DBS tuner

For the VCR

For the TV

DVR/DVD (for “DIGITAL IN 1”)
DBS (for “DIGITAL IN 2”)
VCR (for “DIGITAL IN 3”)

•  You cannot assign the same component for different terminals.
  The priority order for assignment is as follows:
  “DIGITAL IN 1” > “DIGITAL IN 2” > “DIGITAL IN 3”

  Ex.: When “DIGITAL IN 1” is set to “DVR/DVD.”

DBS

VCR

TV

‘

For “DIGITAL IN 2,” “DBS,” “VCR,” and “TV” are selectable.
•  In this case, “VCR” is selected.

DVR/DVD

DBS

TV

‘

For “DIGITAL IN 3,” “DBS” and “TV” are selectable.

DVR/DVD

VCR

: Selectable

: Not selectable

•  Setting “DIGITAL IN 1” affects “DIGITAL IN 2” and “DIGITAL IN 3” 

settings. When you have changed “DIGITAL IN 1,” confirm the 
components assigned to “DIGITAL IN 2” and “DIGITAL IN 3.”

Synchronization between audio and video reproduction can 
be possibly disturbed because video signal decoding is time-
consuming compared to the audio signal decoding.
On this setting, you can correct synchronization between 
video and audio signals by delaying the audio signal timing.

Adjustable range: OFF and 10 ms to 150 ms (in 10 ms 

intervals)

OFF

The audio delay level setting does not take effect when selecting “A 
MULTI” for the audio input setting (see page 11).

When you connect a VCR or DBS to the HDMI VCR(DBS) IN 
terminal or COMPONENT VIDEO jacks on the rear of the 
receiver, you need to select either “VCR” or “DBS” for each 
terminal according to the component you connect.
If you have not selected an appropriate source, you cannot 
view the playback picture on the TV.

Select this when connecting a VCR to the 
HDMI terminal.

Select this when connecting a DBS tuner to 
the HDMI terminal.

VCR

Select this when connecting a VCR to the 
COMPONENT VIDEO jacks.

Select this when connecting a DBS tuner to 
the COMPONENT VIDEO jacks.

VCR

When you connect your TV and this receiver with the HDMI 
cable, set this setting to “HDMI.”
With this setting, this receiver converts incoming composite 
video, S-video, and component video signals from video 
components and transmits the converted signals through the 
HDMI cable.

Select this when connecting a TV to the 
HDMI terminal.

Select this when connecting a TV to any 
video jack other than the HDMI terminal.

HDMI

When selecting “HDMI,” the AV COMPU LINK remote control system is 
restricted (see page 45).

34

29-34_BasicSt.indd   34

29-34_BasicSt.indd   34

06.5.19   1:14:36 PM

06.5.19   1:14:36 PM