ONKYO TX-NR5009 用户手册

En

By using ACTIVITIES in Easy macro mode, you can 
sequentially operate Onkyo components via simple 
commands from a single-button press. These commands 
are user-definable. See “Using Normal Macros” 
(

).

■

First, the TV, the Onkyo Blu-ray Disc player, and the AV 
receiver are turned on. The input selector is set to 
“BD/DVD”. Finally the player starts playback.

*1

*1

Depending on the start-up time of your Blu-ray Disc/DVD 
player, the AV receiver may not activate this playback 

command. In this case, press 

1 on the remote controller.

■

First, the TV, the cable set-top box, and the AV receiver 
are turned on. Then the input selector is set to 
“CBL/SAT”.

■

The Onkyo CD player and the AV receiver are turned on. 
The input selector is set to “TV/CD”. Finally, the player 
starts playback.

• While the Easy Macro command is being processed, you cannot 

use other ACTIVITIES. If you want to operate other 
components, first press ALL OFF and use the desired 
ACTIVITIES.

This button turns off all components activated by the Easy 
Macro mode.

First, the related components stop and turn off. Second, 
the AV receiver turns off. Finally, the TV turns off (or 
enters standby mode).

*1*2

*1

This step doesn’t apply to MY MUSIC, with the default 
settings.

*2

With some televisions, the power may not be turned off (or 
enter standby mode).

You can change the source components activated by the 
Easy Macro mode.

Examples:
If you wished to use MY MOVIE to start the playback 
component assigned to VCR/DVR of REMOTE MODE, 
you would press and hold down MY MOVIE for about 3 
seconds while pressing down VCR/DVR of REMOTE 
MODE.

You can restore ACTIVITIES to the default settings.

This section explains how to record the selected input 
source to a component with recording capability.

Audio sources can be recorded to a recorder (e.g., cassette 
tape deck, CDR, MD recorder). Video sources can be 
recorded to a video recorder (e.g., VCR, DVD recorder).

MY MUSIC) to start the Easy macro command.
The default sequences of actions are described below. 
To change the related source component, see 
“Changing the Source Components” shown later in 
this chapter.

seconds).
ACTIVITIES flashes twice, indicating that the 
change is complete.

again.
ALL OFF flashes twice.

Use the input selector buttons to select the source 
that you want to record.
You can watch the source while recording. The AV 
receiver’s MASTER VOLUME control has no effect 
on recording.

On the source component, start playback.
If you select another input source during recording, 
that input source will be recorded.