Sennheiser I EM 3732-II Command 用户手册
Using the receiver
20
To monitor the audio signal of one of the two receivers of a twin receiver:
왘
Press the headphone button
0
of the receiver whose audio signal you
want to monitor.
To simultaneously monitor the audio signals of both receivers of a twin
receiver:
receiver:
왘
Simultaneously press the headphone buttons
0
of both receivers.
The audio signal of the left receiver is output via the left headphone
channel, the audio signal of the right receiver is output via the right
headphone channel.
channel, the audio signal of the right receiver is output via the right
headphone channel.
왘
Gradually increase the volume.
To switch the headphone output off:
왘
Press the headphone button
0
of the receiver whose headphone
output you want to switch off.
Deactivating the lock mode
When the receivers are remote controlled via a PC and the “Wireless
Systems Manager” software, their buttons can be locked via the “Wireless
Systems Manager” software. To deactivate the lock mode:
Systems Manager” software, their buttons can be locked via the “Wireless
Systems Manager” software. To deactivate the lock mode:
왘
Press the
esc
button
until the progress bar is complete and the
status display appears.
The lock mode is deactivated and the settings can be made manually.
The lock mode is deactivated and the settings can be made manually.
Synchronizing a transmitter with the receiver
Via its infra-red interface, the receiver can transfer the frequency and the
name to suitable transmitters (e.g. SK 5212-II, SKM 5200-II, SK 5212,
SKM 5200 or SKP 3000).
name to suitable transmitters (e.g. SK 5212-II, SKM 5200-II, SK 5212,
SKM 5200 or SKP 3000).
왘
Make sure that the HDP compander system is activated on your
receiver (siehe “Selecting the compander system” on page 37).
receiver (siehe “Selecting the compander system” on page 37).
왘
Set the receiver to the desired receiving frequency (see page 29) and
enter the desired name (see page 30).
enter the desired name (see page 30).
왘
Press the
sync
button
on your receiver.
The two blue LEDs in the infra-red interface (sync)
flash and the
backlighting of the
sync
button
flashes red. The receiver is ready for
synchronization.
esc
s
ave
syn
c
300
100
100
30
10
10
10
50
100
PEAK
µV
RF
% DEV
M
H
z
776.000
01.01
BANK
CH
CH
A
B
0
6
COM
AF
HD
P
Hold esc to unlock
The transmitter must be from a compatible frequency range and be
equipped with the same compander system (HDP, see page 41) as
the receiver. With transmitters that are equipped with HDX (e.g.
2000 series and es G3), synchronization via the infra-red interface
or a firmware update is not possible.
equipped with the same compander system (HDP, see page 41) as
the receiver. With transmitters that are equipped with HDX (e.g.
2000 series and es G3), synchronization via the infra-red interface
or a firmware update is not possible.
esc
s
ave
syn
c
digital audio
processing
syn
c
EV
M
H
z
776.000
01.01
BANK
CH
CH
9
A
COM
AF
HD
P
The
sync
button
“Wireless Systems Manager” software. For more information, refer
to page 22.
to page 22.