Pioneer VSX-709RDS 用户手册

En

When you select a function (for example,  CD) that is only hooked up by a digital connection, then the
ANALOG/DIGITAL signal input switch will automatically choose digital. If you have that function hooked
up by both digital and analog connections this switch lets you choose which to listen to.

This switches the remote control to the surround setup mode.

Each press switches between ANALOG and DIGITAL signal
selection.

While SIGNAL SELECT is set to DIGITAL, 2
DIGITAL lights when a Dolby Digital signal is
input, DTS lights when a DTS signal is input.

• SIGNAL SELECT is fixed in the “ANALOG” position for components

not assigned to one of the two digital input jacks.

• This receiver can only play back Dolby Digital, PCM (32kHz, 44kHz,

and 48kHz), DTS,  digital signal formats. With digital signal formats
other than these, set SIGNAL SELECT to “ANALOG”.

• When an LD or  CD player compatible with DTS is played back with

SIGNAL SELECT set in “ANALOG”, digital noise is output caused by
playing back the DTS directly (no decoding). To prevent noise, you
need to make digital connections (Refer to page 9) and set SIGNAL
SELECT to “DIGITAL”.

• Some DVD players don’t output DTS signals. For more details, refer

to the instruction manual supplied with your DVD player.

Each press switches between ANALOG
and DIGITAL signal selection.

When a Dolby Digital
signal is input.

When a DTS
signal is input.

2

Î

2