Pioneer VSX-322-K 用户手册

En

You can search for a program type listed above.

• RDS is only possible in the FM band.

 shows in the display.

/ to select the program type you 

The system starts searching through the station presets for a 

match, stopping when it was found one. Repeat to search for 

other stations.
If NO PTY is displayed it means the tuner couldn’t find that 

program type at the time of the search.

• RDS searches station presets only. If no stations have 

been preset, or if the program type could not be found 

among the station presets NO PTY is displayed. FINISH 

means the search is complete.

Use the DISP button to display the different types of RDS 

information available.
 Press DISP for RDS information.

Each press changes the display as follows:

• Listening mode
• Master  volume
• Radio Text (RT) – Messages sent by the radio station. For 

example, a talk radio station may provide a phone number 

as RT.

• Program Service Name (PS) – The name of the radio 

station.

• Program  Type  (PTY) – This indicates the kind of program 

currently being broadcast.

• Current tuner frequency (FREQ)

• If any noise is picked up while displaying the RT scroll, 

some characters may be displayed incorrectly.

• If you see NO TEXT in the RT display, it means no RT data 

is sent from the broadcast station. The display will 

automatically switch to the PS data display (if no PS data, 
NO NAME

 is displayed).

• In the PTY display, NO PTY may be shown.

You can make an audio recording from the built-in tuner, or 

from an audio source connected to the receiver (such as a 

CD player). 
Only audio signals that were input to this receiver through a  

analog audio inputs can be recorded. Signals that were input 

through an HDMI cable or digital audio cable (optical / 

coaxial) cannot be recorded (see Connecting other audio 

components on page 15 for more on connections). 

The input of the receiver will switch over, and you will be able 

to operate other components using the remote control.

• The input source can also be selected by using INPUT 

 

 buttons on the remote control, or by 

using the front panel INPUT SELECTOR dial.

Press SIGNAL SEL and select the analog inputs (A) for the 

source component of which you want to record (see page 17 

for more on this).

Tune to the radio station, load the CD etc.

Insert a blank tape, MD etc. into the recording device and set 

the recording levels.
Refer to the instructions that came with the recorder if you 

are unsure how to do this.

• The receiver’s volume, balance, tone (bass, treble, 

loudness), and surround effects have no effect on the 

recorded signal.