Pioneer VSX-322-K 用户手册

En

Press 

 first to access:

, TRE –/+ – Use to adjust Bass or Treble.

• These controls are disabled when the listening mode is 

set to DIRECT or PURE DIRECT.

• When the front speaker is set at SMALL in the Speaker 

Setting and the X.OVER is set above 150 Hz, the 

subwoofer channel level will be adjusted by pressing 
BASS –/+

 (page 26).

Use the number buttons to directly select a radio frequency 

(page 18) or the tracks on a CD, etc. There are other buttons 

that can be accessed after 

 is pressed. (For 

example MIDNIGHT, etc.)

*, DVD*, VCR* – These buttons switch between the 

hard disk, DVD and VCR controls for HDD/DVD/VCR 

recorders.
SB CH

 – Press to select ON, AUTO or OFF the surround 

back channel (page 23).
CH SELECT

 – Press repeatedly to select a channel, then 

use LEV +/– to adjust the level (page 26).
LEV +/–

 – Use to adjust the channel level.

 – Switches to Midnight or Loudness listening 

(page 23).
SPEAKERS

 – Use to change the speaker system on or off. 

When the SP OFF is selected, no sound is output from the 

speakers connected to this receiver.
DIMMER

 – Dims or brightens the display. The brightness 

can be controlled in four steps.

 SOURCE

Turns on or off the power of the Pioneer DVD/DVR units when 
BD

, DVD, DVR/BDR or CD is selected using the input 

function buttons. 

These buttons can control only be used with Pioneer TVs.

 – Use to turn on/off the power of the TV.
INPUT

 – Use to select the TV input signal.

 – Use to select channels.

 – Use to adjust the volume on your TV.

* – Switches between the DTV and analog TV 

input modes for Pioneer TVs.

Use to set the listening volume.

Mutes/unmutes the sound.

Switches the display of this unit. The listening mode, sound 

volume or input name can be checked by selecting an input 

source.

Press to access the ‘boxed’ commands (above the buttons) 

on the remote. These buttons are marked with an asterisk (*) 

in this section.

The batteries included with the unit are to check initial 

operations; they may not last over a long period. We 

recommend using alkaline batteries that have a longer life.

• Incorrect use of batteries may result in such hazards as 

leakage and bursting. Observe the following precautions:

-

Never use new and old batteries together.

-

Insert the plus and minus sides of the batteries properly 

according to the marks in the battery case.

-

Batteries with the same shape may have different 

voltages. Do not use different batteries together.

-

When disposing of used batteries, please comply with 

governmental regulations or environmental public 

institution’s rules that apply in your country or area.

-

Do not use or store batteries in direct sunlight or other 

excessively hot place, such as inside a car or near a 

heater. This can cause batteries to leak, overheat, 

explode or catch fire. It can also reduce the life or 

performance of batteries.

Store the batteries out of the reach of children and infants. If 

accidentally swallowed, contact a doctor immediately.

The remote control may not work properly if:

• There are obstacles between the remote control and the 

receiver’s remote sensor.

• Direct sunlight or fluorescent light is shining onto the 

remote sensor.

• The receiver is located near a device that is emitting 

infrared rays.

• The receiver is operated simultaneously with another 

infrared remote control unit.

30°

7 m

30°