Pioneer VSX-1325-K 用户手册

下载
页码 112
Connecting your equipment
03
18
En
[E] 5.1 channel surround system & ZONE 2 
connection (Multi Zone)
• Speaker System setting: ZONE 2
With these connections you can simultaneously enjoy 
5.1-channel surround sound in the main zone with stereo 
playback on another component in ZONE 2. (The 
selection of input devices is limited.)
 Important
• The Speaker System setting must be made if you 
use any of the connections shown above other than 
[A] (see Speaker system setting on page 83).
• Sound does not come through simultaneously from 
the front height, front wide, speaker B and surround 
back speakers. Output speakers are different 
depending on the input signal or listening mode.
Other speaker connections
• Your favorite speaker connections can be selected 
even if you have fewer than 5.1 speakers (except front 
left/right speakers).
• When not connecting a subwoofer, connect speakers 
with low frequency reproduction capabilities to the 
front channel. (The subwoofer’s low frequency 
component is played from the front speakers, so the 
speakers could be damaged.)
• After connecting, be sure to conduct the Auto 
MCACC (speaker environment setting) procedure.
See Automatically conducting optimum sound tuning 
(Auto MCACC)
 on page 37.
Placing the speakers
Refer to the chart below for placement of the speakers 
you intend to connect.
• Place  the  surround speakers at 120º from the center. 
If you, (1) use the surround back speaker, and, (2) 
don’t use the front height speakers / front wide 
speakers, we recommend placing the surround 
speaker right beside you.
• If you intend to connect only one surround back 
speaker, place it directly behind you.
• Place the left and right front height speakers at least 
one meter (3.3 ft.) directly above the left and right 
front speakers.
THX speaker system setup
If you are using a THX certified subwoofer, use the THX 
INPUT
 jack on the subwoofer (if your subwoofer has one) 
or switch the filter position to THX on your subwoofer.
See also THX Audio Setting on page 85  to make the 
settings that will give you the best sound experience 
when using the Home THX modes (page 53).
Some tips for improving sound quality
Where you put your speakers in the room has a big effect 
on the quality of the sound. The following guidelines 
should help you to get the best sound from your system.
• The  subwoofer can be placed on the floor. Ideally, the 
other speakers should be at about ear-level when 
you’re listening to them. Putting the speakers on the 
floor (except the subwoofer), or mounting them very 
high on a wall is not recommended.
• For the best stereo effect, place the front speakers 2 
m to 3 m (6 ft. to 9 ft.) apart, at equal distance from 
the TV.
• If  you’re going to place speakers around your CRT TV, 
use shielded speakers or place the speakers at a 
sufficient distance from your CRT TV.
• If  you’re using a center speaker, place the front 
speakers at a wider angle. If not, place them at a 
narrower angle.
L
L
R
R
SL
SW
C
SR
Main zone
Sub zone
ZONE 2
L
SW
C
FHL
FWL
SL
SBL
SBR
SB
SR
FWR
R
FHR
30
30
60
60
60
120
120
VSX-1325_UXJCB.book  18 ページ  2010年3月9日 火曜日 午後3時4分