Pioneer VSX-919AH-S 用户手册

En

• Auto MCACC – The default is ALL 

(recommended), but you can limit the 
system calibration to only one setting (to 
save time) if you want.

1

 The available 

options are ALL, Keep SP System,

2

 

Speaker Setting, Channel Level, 
Speaker Distance and EQ Pro & S-Wave.

• EQ Type (only available when the Auto 

MCACC Menu above is EQ Pro & S-Wave) 
– This determines how the frequency 
balance is adjusted.

After a single calibration is performed, each of 
the following three correction curves can be 
stored separately in the MCACC memory. 
SYMMETRY (default) implements symmetric 
correction for each pair of left and right 
speakers to flatten the frequency-amplitude 
characteristics. ALL CH ADJ is a ‘flat’ setting 
where all the speakers are set individually so 
no special weighting is given to any one 

channel. FRONT ALIGN

3

 sets all speakers in 

accordance with the front speaker settings (no 
equalization is applied to the front left and right 
channels).

• THX Speaker (only available when the 

Auto MCACC Menu above is ALL or 
Speaker Setting) – Select YES if you are 
using THX speakers (set all speakers to 
SMALL), otherwise leave it set to NO.

• STAND.WAVE Multi-Point (only available 

when the Auto MCACC Menu above is EQ 
Pro & S-Wave) – In addition to 
measurements at the listening position, 
you can use two more reference points for 
which test tones will be analyzed for 
standing waves. This is useful if you want to 
get a balanced ‘flat’ calibration for several 

seating positions in your listening area.

4

 

Place the microphone at the reference 
point indicated on-screen and note the last 
microphone placement will be at your main 
listening position:

• Push down on the PUSH OPEN tab to 

access the MCACC SETUP MIC jack.

Make sure there are no obstacles between the 
speakers and the microphone.

If you have a tripod, use it to place the 
microphone so that it’s about ear level at your 
normal listening position. Otherwise, place the 
microphone at ear level using a table or a chair.

1 •  The  EQ Pro & S-Wave measurement is also taken when Keep SP System or EQ Pro & S-Wave is selected. See 

Acoustic Calibration EQ Professional on page 85 for more on this.
• Either effect of Acoustic Calibration EQ Professional and Standing Wave can be switched on and off in the 
respective MCACC preset. For details, see Setting the Audio options on page 63.

2 The Keep SP System option allows you to calibrate your system while leaving your current speaker setting (page 94) 

unchanged.

3 If you selected ALL as your Auto MCACC menu, you can specify the MCACC preset where you want to save the ALL 

CH ADJ and FRONT ALIGN settings.

4 Switch  the  Multi-Point setting NO if you only use one listening position.

2nd reference 

point

3rd reference 

point

Main listening 

position

VSX-1019_DF.book  78 ページ  ２００９年３月１３日　金曜日　午前９時５８分