Sony STR-DG1000 用户指南
118
GB
The image of the COMPONENT VIDEO
OUT is corrupted.
OUT is corrupted.
• When the signals are output from the
COMPONENT VIDEO OUT jack, input
signals other than 480p are corrupted if
“PROGRESSIVE OUT” is set to “ON.”
Set “PROGRESSIVE OUT” to “OFF.”
signals other than 480p are corrupted if
“PROGRESSIVE OUT” is set to “ON.”
Set “PROGRESSIVE OUT” to “OFF.”
• Video input signals other than 480p
component are not received when signals
are output from the S VIDEO jack or the
VIDEO jack. Input 480i component video
signals.
are output from the S VIDEO jack or the
VIDEO jack. Input 480i component video
signals.
• When component input signals other than
480p are output, use the COMPONENT
VIDEO OUT jack and set
“PROGRESSIVE OUT” to “OFF.”
VIDEO OUT jack and set
“PROGRESSIVE OUT” to “OFF.”
The source image input from the HDMI
jack is not output from the receiver or
the TV speaker connected to the
receiver.
jack is not output from the receiver or
the TV speaker connected to the
receiver.
• Make sure that cables are correctly and
securely connected to components.
• Depending on the playback component,
component may need to be set up. Refer to
the operating instructions supplied with
the each component.
the operating instructions supplied with
the each component.
Recording cannot be carried out.
• Check that the components are connected
correctly (page 24).
• Select the source component using INPUT
SELECTOR (page 48).
Tuner
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground (earth) wire to a gas pipe.
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground (earth) wire to a gas pipe.
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
(aerials) and connect an external antenna
(aerial), if necessary.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning.
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 82).
scanning preset stations). Preset the
stations (page 82).
• Press DISPLAY so that the frequency
appears on the display.
Remote control
The remote does not function.
• Point the remote at the remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure that the command modes of the
receiver and the remote are the same. If the
command mode of the receiver and the
remote are different, you cannot operate
the receiver with the remote (page 38).
command mode of the receiver and the
remote are different, you cannot operate
the receiver with the remote (page 38).
Receiver
To ground
Ground (earth) wire (not supplied)
Outdoor FM antenna (aerial)