Sony STR-DG920 用户手册

下载
页码 116
99
US
 
 
 
 
 
 
 
 
Us
ing
 the
 Re
m
o
te
Selecting a preset channel
1
Press XM to select “XM RADIO”.
2
Press PRESET+ or PRESET – repeatedly to 
select the preset channel you want.
You can also press SHIFT, then press 
numeric buttons to select the preset channel 
you want. Then, press ENT/MEM to enter 
the selection.
You can also press TUNING MODE on the 
receiver repeatedly to select “PRESET” 
then use TUNING +/– to select the preset 
channels you want.
Programming the remote
You can customize the remote to match the 
components connected to your receiver. You 
can even program the remote to control non-
Sony components and also Sony components 
that the remote is normally unable to control.
The procedure below uses as an example a 
case in which a VCR made by a company 
other than Sony is connected to the VIDEO 1 
IN jacks on the receiver.
Before you begin, note that:
– You cannot change the settings of PHONO.
– The remote can control only components 
that accept infrared wireless control signals.
Be sure to turn on the receiver and 
point the remote towards the 
receiver when performing the 
following procedure.
1
Press and hold RM SET UP, 
then press AV 
?/1.
The RM SET UP indicator slowly flashes.
2
Press the input button 
(including TV) for the 
component you want to control.
For example, if you are going to control a 
VCR connected to VIDEO 1 IN, press 
VIDEO 1.
The RM SET UP and SHIFT indicator 
light up.
If you press the button for a component of 
which you cannot program the remote, 
such as DMPORT, XM, etc., the RM SET 
UP indicator keeps flashing.
Using the Remote
continued