Sony R-DG1200 用户手册

D:\NORMAN_PC\JOBS\SONY HA\STR-DG1200\U\3289135111\01US-
STRDG1200CEL\110ADD.fm

STR-DG1200

3-289-135-11(1)

• The receiving condition is not good. Move 

the antenna to the place where the 
condition is good.

• Check that you subscribed to the desired 

satellite radio service (see page 72).

• Point the remote at the remote sensor on 

the receiver.

• Remove any obstacles in the path between 

the remote and the receiver.

• Replace all the batteries in the remote with 

new ones, if they are weak.

• Make sure that the command modes of the 

receiver and the remote are the same. If the 
command mode of the receiver and the 
remote are different, you cannot operate 
the receiver with the remote (page 35).

• Make sure you select the correct input on 

the remote.

• When you operate a programmed non-

Sony component, the remote may not 
function properly depending on the model 
and the maker of the component.

Error messages
If there is a malfunction, the display window 
shows a message. You can check the condition 
of the system by the message. Refer to the 
following table to solve the problem. If any 
problem persists, consult your nearest Sony 
dealer.

Irregular current is output to the speakers, or 
the upper panel of the receiver is covered 
with something. The receiver will 
automatically turn off after a few seconds. 
Check the connection of speakers and turn 
on the power again.

For other messages, see “Message list after 
Auto Calibration measurement” (page 46),  
“XM Radio message list” (page 81), “SIRIUS 
Satellite Radio message list” (page 82)

 

and 

All memorized settings

Customized sound fields