Sony R-DG1200 用户手册

D:\NORMAN_PC\JOBS\SONY HA\STR-DG1200\U\3289135111\01US-
STRDG1200CEL\030CON.fm

STR-DG1200

3-289-135-11(1)

Insert two R6 (size-AA) batteries in the RM-
AAL019 Remote Commander.
Observe the correct polarity when installing 
batteries.

• Do not leave the remote in an extremely hot or 

humid place.

• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of 

batteries.

• Do not expose the remote sensor to direct sunlight 

or lighting apparatuses. Doing so may cause a 
malfunction.

• If you do not intend to use the remote for an 

extended period of time, remove the batteries to 
avoid possible damage from battery leakage and 
corrosion.

• When you replace the batteries, the programmed 

remote codes may be cleared. If this happens, 
program the remote codes again (page 115).

When the remote no longer operates the receiver, 
replace all the batteries with new ones.

The receiver and the remote use the same 
command mode.
If the command modes of the receiver and the 
remote are different, you cannot use the 
remote to operate the receiver.
If the command modes of both the receiver and 
the remote are those of the initial setting (AV 
SYSTEM 2), it is not necessary to reset them.
You can switch the command mode (AV 
SYSTEM 1 or AV SYSTEM 2) of the receiver 
and the remote. If both the receiver and the 
other Sony component respond to the same 
remote command, switch the command mode 
of either the component or the receiver to 
another command mode so that the component 
does not respond to the same remote command 
as the receiver.

When the command mode is set to “AV2”, 
“C. MODE AV2” appears on the display 
window.
When the command mode is set to “AV1”, 
“C. MODE AV1” appears on the display 
window.

POWER

2CH/A.DIRECT