Sony R-DG1200 用户手册

D:\NORMAN_PC\JOBS\SONY HA\STR-DG1200\U\3289135111\01US-
STRDG1200CEL\030CON.fm

STR-DG1200

3-289-135-11(1)

*

xxx represents a speaker channel.

F

Front

FL

Front Left

FR

Front Right

CNT

Center

SL

Surround Left

SR

Surround Right

SB

Surround Back

SBL

Surround Back Left

SBR

Surround Back Right

SW

Subwoofer

Press 

B/b to select “Retry”, then press 

.

Press 

 to select “Start”.

Follow the instructions from step 7 of 
“Performing Auto Calibration”.

If a warning on the measurement result is 
present, detailed information is displayed.

Press 

 to return to step 1 of 

Depending on the position of the subwoofer, the 
measurement results for polarity may vary. 
However, there will be no problems even if you 
continue to use the receiver with that value.

Error Code: 31
[E-xxx: 31]*

SPEAKERS (OFF/A/B/A+B) is set to off. Set it to others and perform the measurement 
again.

Error Code: 32
[E-xxx: 32]*

None of the speakers were detected. Make sure that the optimizer microphone is connected 
properly and perform the measurement again.
If the optimizer microphone is connected properly but the error code appears, the optimizer 
microphone cable may be damaged or improperly connected.

Error Code: 33
[E-xxx: 33]*

• None of the front speakers are connected or only one front speaker is connected.
• The optimizer microphone is not connected.
• Either the left or right surround speakers is not connected.
• Surround back speakers are connected even though surround speakers are not connected. 

Connect the surround speaker(s) to the SURROUND terminals.

• The surround back speaker is connected only to the SURROUND BACK SPEAKERS R 

terminals. When you connect only one surround back speaker, connect it to the 
SURROUND BACK SPEAKERS L terminals.

Warning Code: 40
[W-xxx: 40]*

The measurement has completed. However, the noise level is high. You may be able to 
perform the measurement properly if you try it again, even though the measurement cannot 
be performed in all environments. Try to perform the measurement in a quiet environment.

Warning Code: 41
[W-xxx: 41]*

The input from the microphone is too loud. The distance between the speaker and the 
microphone may be too close with each other. Retry the measurement after setting them 
further apart from each other.

Warning Code: 42
[W-xxx: 42]*

The input from the microphone is too loud. The distance between the speaker and the 
microphone may be too close with each other. Retry the measurement after setting them 
further apart from each other.

Warning Code: 43
[W-xxx: 43]*

The distance and position of a subwoofer cannot be detected. This may be caused by noise. 
Try to perform the measurement in a quiet environment.

NO WARNING

There is no warning information.