Sony STR-DN2010 用户手册

D:\NORM'S JOB\SONY HA\SO0071\STR-DN2010\GB\GB05ENJ_STR-DN2010-CEL.fm

STR-DN2010

4-182-049-11(1)

 

 

 

 

 

 

 

 

 

You can make the required settings for 
components connected to the HDMI jack.

Lets you turn the Control for HDMI function 
on or off. For details, see “Preparing for the 
“BRAVIA” Sync” (page 90).

x ON

x OFF

When you set “Control for HDMI” to “ON”, “Audio 
Out” may be changed automatically.

Lets you output the HDMI signals to the TV 
even when the receiver is in standby mode.

x OFF

The receiver does not output HDMI signals 
when the receiver is in the standby mode.
Turn on the receiver to enjoy the connected 
component’s source on the TV. This setting 
saves power in the standby mode compared 
with the “ON” setting.

x AUTO

When the TV is turned on while the receiver is 
in the standby mode, the receiver outputs 
HDMI signals from the receiver’s HDMI TV 
OUT jack. Sony recommends this setting if 
you use a TV that is compatible with 
“BRAVIA” Sync. This setting saves power in 
the standby mode compared with the “ON” 
setting.

x ON

When the receiver is in the standby mode, the 
receiver continuously outputs HDMI signals 
from the receiver’s HDMI TV OUT jack.

• This parameter is not available when “Control for 

HDMI” is set to “OFF”.

• When “AUTO” is selected, it may take a little more 

time for the image and sound to be output to the TV 
than when “ON” is selected.

• When the receiver is in standby mode, 

 

“A. STANDBY” appears on the display if “Pass 
Through” is set to “AUTO” or “ON”. However, 
“A. STANDBY” will disappear when “Pass 
Through” is set to “AUTO” and no signals are 
detected.

Lets you set the HDMI audio signals from the 
playback component connected to the receiver 
via an HDMI connection.

x TV+AMP

The sound is output from TV’s speaker and the 
speakers connected to the receiver.

• The sound quality of the playback component 

depends on the TV’s sound quality, such as the 
number of channels, and the sampling frequency, 
etc. When the TV has stereo speakers, the sound 
output from the receiver is also stereo as that of the 
TV, even if you play back multi channel source.

• When you connect the receiver to an image display 

component (projector, etc.), sound may not be 
output from the receiver. In this case, select 
“AMP”.

• When you select the input that you have assigned 

the HDMI input, sound does not output from the 
TV.

x AMP

The HDMI audio signals from the playback 
component is only output to the speakers 
connected to the receiver. Multi channel sound 
can be played back as it is.

Audio signals are not output from the TV’s speaker 
when “Audio Out” is set to “AMP”.