Sony STR-DE485 用户手册

STR-DE485 4-238-376-51(1) GB

Outdoor FM antenna

Receiver

Ground wire
(not supplied)

To ground

ANTENNA

COAXIAL

The FM reception is poor.

Use a 75-ohm coaxial cable (not supplied) to
connect the receiver to an outdoor FM antenna as
shown below. If you connect the receiver to an
outdoor antenna, ground it against lightning. To
prevent a gas explosion, do not connect the ground
wire to a gas pipe.

Radio stations cannot be tuned in.

• Check that the antennas are connected securely.

Adjust the antennas and connect an external
antenna if necessary.

• The signal strength of the stations is too weak

(when tuning in with automatic tuning). Use
direct tuning.

• Make sure you set the tuning interval correctly

(when tuning in AM stations with direct tuning).

• No stations have been preset or the preset

stations have been cleared (when tuning by
scanning preset stations). Preset the stations
(page 30).

• Press DISPLAY so that the frequency appears in

the display.

There is no picture or an unclear picture appears
on the TV screen or monitor.

• Select the appropriate function on the receiver.

• Set your TV to the appropriate input mode.

• Move your TV away from the audio components.

The remote does not function.

• Point the remote at the remote sensor

g on the

receiver.

• Check that you select AV2 as the command

mode of the receiver (page 33).

• Remove any obstacles in the path between the

remote and the receiver.

• Replace both batteries in the remote with new

ones, if they are weak.

• Make sure you select the correct function on the

remote.

• If the remote is set to operate the TV only, use

the remote to select a source or component other
than TV before operating the receiver or other
component.

Clearing the receiver’s memory

To clear

See

All memorized settings

page 15

Customized sound fields

page 27

Troubleshooting (continued)

01GB11ADDCEL.p65

4/15/02, 5:09 PM