Sony 3-875-814-21(1) 用户手册

• No stations have been preset or the preset 

stations have been cleared (when tuning by 
scanning preset stations). Preset the 
stations (page 66).

• Press DISPLAY so that the frequency 

appears on the display.

• Make sure that you are tuned to an FM 

RDS station.

• Select a stronger FM station.

• Contact the radio station and find out 

whether or not they actually provide the 
service in question. If so, the service may 
be temporarily out of order.

• Check the HDMI connection (page 33).
• Make sure “Control for HDMI” is set to 

“ON” in HDMI settings menu. 

• Make sure the connected component is 

compatible with the Control for HDMI 
function.

• Check the Control for HDMI settings on 

the connected component. See the 
operating instructions of the connected 
component.

• If you change the HDMI connection, 

connect/disconnect the AC power cord, or 
there is a power failure, repeat the 
procedures of “Preparing for the 
“BRAVIA” Sync” (page 86).

• If you select HDMI B using the HDMI 

OUTPUT button, after you have selected 
HDMI A, the Control for HDMI function 
may not work properly for a while. This is 
because the component connected to the 
HDMI A jack must re-recognize the 
receiver that is equipped with the Control 
for HDMI function. If the Control for 
HDMI function does not work properly for 

a long time, perform the steps given in 
“Preparing for the “BRAVIA” Sync” 
(page 86).

• When HDMI B is selected, the Control for 

HDMI function does not work.

• Make sure the TV is compatible with the 

System Audio Control function.

• If the TV does not have System Audio 

Control function, set the “Audio Out” 
settings in HDMI settings menu to
– “TV+AMP” if you want to listen to the 

sound from the TV speaker and 
receiver.

– “AMP” if you want to listen to the 

sound from the receiver.

• You cannot listen to the sound of a 

component connected to the receiver while 
a TV is selected as the input on the 
receiver.
– Change the input of the receiver to 

HDMI when you want to watch a 
program on a component connected to 
the receiver.

– Change the TV channel when you want 

to watch a TV broadcast.

– Select the component or input you want 

to watch when you watch a program on 
the component connected to the TV.
Refer to the operating instructions of the 
TV on this operation.

• When using the Control for HDMI 

function, you cannot control the connected 
component using TV’s remote.
– Depending on the connected component 

and TV, you may need to set up the 
component and TV. Refer to the 
operation instructions supplied with 
each component and TV.

– Change the input of the receiver to the 

HDMI input connected to the 
component.