Telex MCE325 用户手册

4-9

Move the J4 jumper to short pins 1 and 2 (IFB A assigned to channel 3).

Remove the signal from PROGRAM B input, and connect it to the PROGRAM A input. Set 
the signal generator to 0 dBu, 1 kHz.

Check the output level across intercom channel 3. It should be –9.8 dBu ±2 dBu.

Turn on the CH 3 TALK and MIC ON buttons. The channel 3 output should drop at least 45 
dB from the reference level in step 3.

Turn off the CH 3 TALK and MIC ON buttons.

Ground the Key 3 input (short J22 pin 7 to pin 10). The channel 3 output should drop at least 
45 dB from the reference level in step 3. 

Remove the Key 3 ground.

Move the J4 jumper to short pins 2 and 3.

Set all front panel buttons to off. Set all volume controls to minimum.

Remove the signal generator from the Program A input, and connect it to the Four-Wire A 
input (AUXILIARY connector J22, pins 8 and 21). Set the generator to 0 dBu, 1 kHz.

Move jumper J19 to short pins 3 & 4 (Four-Wire A input always on).

Set the CH 1-3 volume control to measure 0 dBu at the left headphone output. (The control 
should be at about the 2 o’clock position.)

Set the signal generator to 0 dBu, 100 Hz. The left headphone output should be –0.9 dBu ±2 
dBu.

Set the signal generator to 0 dBu, 10 kHz. The left headphone output should be –4.7 dBu ±2 
dBu.

Move jumper J19 to short pins 2 & 3 (Four-Wire A input off).

Remove the signal from the Four-Wire A input, and connect it to the Four-Wire B input (J22, 
pins 9 & 22).

Move jumper J20 to short pins 3 & 4 (Four-Wire B input always on).

Set the CH 2-4 volume control to measure 0 dBu at the right headphone output. (The control 
should be at about the 2 o’clock position.)

Set the signal generator to 0 dBu, 100 Hz. The right headphone output should be –0.9 dBu ±2 
dBu.

Set the signal generator to 0 dBu, 10 kHz. The right headphone output should be –4.7 dBu ±2 
dBu.

Move jumper J20 to short pins 2 &3 (Four-Wire B input off).