Soundstream Technologies 414s 用户指南

l

The 

 and 

 amplifiers incorporate an 

board staggered electronic 

 They also have RCA outputs to drive an

external amplifier. No external electronic crossover is necessary. The high and

low pass portions of the crossover can be set independently of one another.

In most car audio installations, there is a tendency for a 

 boom.”

Because of their interior dimensions, most cars will resonate or ring at these

 frequencies. If we design the system so there is less musical

information in this region, the final response is very smooth and natural
sounding. The high pass filter is variable from 60 to 240 Hz at 12 
while the low pass filter is variable from 30 to 120 Hz at 24 

For initial 

 setup, 

 setting the low pass filter to approximately 60 Hz,

and the high pass filter(s) to approximately 100 Hz. Change the 

points to accommodate a good mixture of frequency response, power handling.
and personal preference.

 

 

summed from Channels I, 

Soundstream’s 

 feature can be added to the REFERENCE6445

 

 amplifiers. This feature allows wireless RF remote 

level adjustment of the amplifier, while the low pass filter on the amplifier’s
internal crossover is engaged.

 does not control the level of the

RCA signal outputs.)

 accessory is added to a 

   Mixed Mono   Bridged Mono switches 

Installing 

involves removing the bottom plate of the amplifier.

adding the 

 circuit board, and flipping a switch. The switch is

labeled on the amplifier’s main circuit board. DO NOT set the 

switch to the “IN” position unless the 

 module has been added. DO

NOT 

 the 

 switch while the amplifier is “ON”. Doing so

may damage your speakers. (Please refer to the 

installation manual for more details.)