Roland 210 用户手册

Used in combination with the COMPRESSION knob (8), 
this switches the compression effect type.

This produces a compression effect like that used in 
recording studios.

This provides the natural, fat compressed sound typical 
of tube amps. This characteristic sense of harmonic-
induced compression is like that produced by slightly 
overdriving a vintage tube bass amp.

This is an effect that compresses overly high signals 
while boosting lower-level input.
Turn the knob to the right increases the compression 
effect.
Turn the knob to the very left to bypass the compression.

Adjusts the tone quality of the lower range.

Adjusts the tone quality of the middle range.

Adjusts the frequency of the middle range.

Adjusts the tone quality of the upper range.

Adjusts the tweeter volume.
This knob affects the tone quality of the range higher 
than that of the TREBLE knob.
No sound is output from the tweeter when this is turned 
to the very left.

This adjusts the balance of the mix between the effect 
sound from the external effect connected to the EFFECT 
jack and the direct sound.

fig.01-01a

The knob settings can be adjusted to accommodate for 
both series and parallel connections.

Models the wide-range sound of tweeter-
equipped bass amps in use since the ’80s.
This amp type produces a dynamic tone with 
a good balance of low-end presence and clear, 
open highs.
Perfect for slap bass.

Creates an aggressive tone in which the pres-
ence of the lower range and the transparency 
of the upper range are greatly augmented.

Adjusts
the balance