Krell Industries 202 用户手册

To access the full array of available functions for the Evolution 202, please read

this entire owner’s reference manual. The abbreviated routine in this Quick Start

section will allow you to connect and operate the Evolution 202 quickly and enjoy

its basic functions. 

The front and rear panels are shown in the diagrams on pages 15 and 22. Each

button or feature is labeled with a callout number, and these numbers are shown

in brackets in the sections below. (In the following instructions, the word “button”

refers to a front panel operation, and “key” refers to a remote control operation.)  

Position the preamplifier and power supply where you intend to use them in

your system. Do not move the chassis after they are connected. 

Connect the power supply chassis and the preamplifier chassis with the 12-pin

DC cable provided, using the back panel DC power connectors (24).

Neatly arrange and organize wiring to and from the preamplifier and all compo-

nents. Separate the AC wires from any audio cables to prevent hum or other

unwanted noise from being introduced into the system.

Connect the outputs of your source equipment to the appropriate CAST (18),

balanced (15), single-ended (16), or tape inputs (17) on the Evolution 202.

Connect the main outputs (20) on the Evolution 202 to your amplifier’s inputs.

Connect the supplied AC power cord to the IEC power cord receptacle (27) of

the power supply unit.

Plug the other end of the AC power cord into AC power. The display (3) scrolls

through 

EVOLUTION 202 SOFTWARE VERSION

, and the stand-by/power LEDs (7) illu-

minate red, indicating that the Evolution 202 is in stand-by mode. When the

scrolling stops, the Evolution 202 is ready to be powered on.