Bogen & X600 用户手册

The Black Max amplifiers were designed to be placed on a table or rack-mounted. For rack-mounted applications,
the amplifiers can be stacked one on top of the other for maximum use of the rack space available without any
extra, empty rack spaces between them.
An open air space of at least 4" must be provided at the front air intakes of the amplifier and the rear exhaust must
have at least 4" between itself and obstructions to ensure adequate cooling. This applies whether racked or
table-mounted.
Care should also be taken to ensure that the front intake air is not considerably warmer than the ambient air tem-
perature. Mount the amplifiers low in the rack so that heat dissipation from other equipment does not warm the
amplifier's intake air.

Rack ears are included with the amplifier to allow mount-
ing in 

19" racks. Attach the rack ears as shown in the

Mechanical Components section. If any feet have been
attached to the bottom of the amplifier, remove them.
Load the amplifier into the rack and secure it  to the rack
with appropriate hardware (not included).

(Optional accessory, not included)
For greater rear support when rack mounting a Black Max
amplifier, the RPK86 Rack Mounting Kit can be attached
to the rear of the amplifier by following these steps:
1. Remove and save the three rearmost cover screws

from the chassis side.

2.

Position the rack attachment as shown.

3.

Replace and tighten the three cover screws to
secure the rack attachments.

4.

Repeat on opposite side of amplifier.

Feet are provided with the amplifier to allow it to be
placed on a tabletop. Attach the included feet to the bot-
tom of the amplifier as shown. Attachment of the rack
ears to the unit is optional and purely aesthetic.

5