Bogen WV250 Manual 用户手册
Panel Descriptions
Wall-Mount Power Vector Module Bay (Rear)
1
. Module Bays
The amplifier has eight module bays, all of which can accommodate input modules, with two bays (bays 7
and 8) that can accommodate either input or output modules.
and 8) that can accommodate either input or output modules.
2. Lo-Cut Switch
Slide switch (located in module bay 6) allows roll off of frequencies below 125 Hz.
3
.Tone Control Bypass Switch
Slide switch (located in module bay 6) allows the effects of the Bass and Treble controls to be bypassed.
Wall-Mount Power Vector Connector Board (Rear)
1
.Trans Output / Direct Out Selector
Allows selection of either “TRANS” for transformer-coupled outputs (70V, 25V, and 8-ohm), or “DIR” for direct
low-impedance (4-ohm minimum) output.
low-impedance (4-ohm minimum) output.
2. Speaker Output Barrier Strip
A terminal barrier strip, with clamping washers, provides connections for speaker loads.
3. Mute Control Terminals
Provides access to mute buses for external control and system expansion.
4. Bridging Mix Bus
An RCA connector that allows the bridging of Power Vectors together for system expansion.
5. Remote Volume Control Terminals
Provides for connection of an RVCP remote volume control panel to control the amplifier’s motorized Master
Volume Control.
Volume Control.
3