Carver px1450 用户手册
13
14
Field Configurable
Gain Controls
Note: The Carver P rofessional limited warranty does not extend to damage resulting from the
following pro c e d u re if attempted by any person not specifically authorized by Carver P ro f e s s i o n a l
following pro c e d u re if attempted by any person not specifically authorized by Carver P ro f e s s i o n a l
CAUTION
To move the gain controls from the front panel to the back panel (or vice versa):
1.Unplug amplifier from power source.
2.Remove top cover (9 screws). Do not allow debris, tools, or hardware to fall inside chassis.
3.Gently pull to remove control knobs from gain controls and remove hole plugs from opposite panel.
4. Remove the 4 screws from gain control circuit board.
5.Carefully move board to opposite panel stand-offs, being sure to keep connector cable free and untwisted.
NOTE: Gently bundle excess cable length and secure with tie wrap.
6.Screw board to threaded stand-offs. Do Not Over Tighten!
7.Put hole plugs in opposite panel.
8.Observing the position of the knob pointers, gently push the control knobs onto the gain controls, or leave
off for screwdriver adjustment.
9.Replace top cover.