Musical Fidelity X-P200 用户手册

All input, output and power

connections should be made with the
mains power switched OFF.

Using good quality co-axial audio leads,
connect the left and right outputs from
your pre-amplifier or other controlled
source to either A or B RCA inputs.

These RCA sockets have “line level”
audio “loop” output routed from either A
or B input by the selector switch on the
front panel.

They are for onward connection to
another amplifier if required.

(See page 6 under BI-AMPLIFICATION).

IEC mains power inlet

The X-P200 is a stereo amplifier, but can
instead be used in “bridge” mode to obtain a
single (mono) output with higher power.

Connect each of your loudspeakers to the
pair of terminals on the back panel marked
LEFT and RIGHT SPEAKER OUTPUT.
The wiring must be “in phase”, namely, the

(+) and black (-) terminals must be

connected to the left and right speakers the
same way round.

Connect a single (mono) loudspeaker
between LEFT and RIGHT

Note that in this mode, the right-hand
channel red terminal becomes negative (-)
for phasing purposes.  This is important for
maintaining correct phase with any other
amplifier being used in your audio system.