MartinLogan Monolith III 用户手册

Page9

Monolith III User's Manual

Please take note of the jumpers installed
across the binding posts of the

IIIp INTER-

FACE..... These jumpers attach the high-pass
and the low-pass sections of the interface
together. Leaving these in place, connect
the (+) wire from your amplifier to either of
the red

AMPLIFIER SIGNAL binding posts of

the Interface and the (-) wire to either of the
black posts. Next, connect the

IIIp INTERFACE

to the

MONOLITH III with the provided cables.

See

Figure 1.

This method of connection replaces the
jumpers installed across the binding posts
of the

IIIp INTERFACE with individual runs of

speaker wire from your amplifier. This
doubles the signal carrying conductors from
the amplifier to the speaker thus, direct-
coupling each portion of the crossover to the
amplifier.

To bi-wire you must first remove the
jumpers from the

IIIp INTERFACE. Connect

one set of wires to the HI+

HI+

HI+ and HI-

HI-

HI- binding

posts of the

IIIp INTERFACE. Then connect a

second set of wires to the LO+

LO+

LO+ and LO-

LO-

binding posts. Next, connect both sets of
wires to the appropriate terminals on your
amplifier. See

Figure 2. Please take care to

connect both (+) wires to the (+) amplifier
terminals and both (-) wires to the (-)
amplifier terminals. This is known as a
parallel connection.

TWO: Bi-wire Connection for the

TWO: Bi-wire Connection for the MONOLITH III

MONOLITH III

MONOLITH IIIp.

IIIp Connection

ONE: Standard Connection for

ONE: Standard Connection for MONOLITH III

MONOLITH III

MONOLITH IIIp

Figure 1

Figure 1: Standard connection for the

MONOLITH IIIp

Figure 2

Figure 2: Bi-wire connection for the

MONOLITH IIIp