MartinLogan STAGECenter Channel Speaker 用户手册

4 

  Place the bracket against the wall at the desired location.

It is important that the entire area behind the bracket, 
and 8.5 inches to the left and right of the bracket be 
free from obstructions and completely flat. 

IMPORTANT! To allow the Stage to fully rotate 
up or down, the following area must be free of 
obstructions:

— 4 inches above of the bracket
— 6 inches below of the bracket
— 8.5 inches left and right of the bracket

5    Using a level, square the bracket and mark the 4 hole 

locations.

6  

Using 

a 

1

/

8

" bit, drill four pilot holes. 

IMPORTANT! If you drill into a stud during this 
step, DO NOT widen the hole and DO NOT 
install a toggle bolt wall anchor at this location—
you will eventually be installing a lag bolt dierctly 
into the stud. 

7  

Use 

a 

1

/

2

" drill bit, widen the  pilot holes so toggle bolt 

wall anchors can be installed.

Figure 5. Level the stand at the mounting location and mark the holes.

Figure 6. Drill pilot holes at the marked locations. Widen any non-stud holes.