Dayton Audio CS820C 产品宣传页

下载
页码 2
 
 
One speaker is playing while the other is not:
  Check the balance control on the receiver. Make sure it is centered.
  Loose connection at either the receiver or the speaker. Double check connections.
  Bad speaker cable. Replace suspect speaker cable.
 
 
Receiver cuts on and off:
  This could be caused by a short circuit between the positive and negative leads. 
Check the connections at the back of the receiver, and then at the speaker; make 
sure that no strands of wire from one connector are touching the other connector.
10.  Caring For Your Ceiling Speakers
 
The two most common ways that ceiling speakers are permanently damaged:
 
 
1)  Not enough power at higher volumes.
 
 
2)  Too much power at higher volumes.
Contrary to conventional wisdom, far more speakers are damaged as a result of under-powering, 
than by overpowering. When a receiver runs out of power, it still tries to reproduce the musical 
signal by “clipping” the waveform. At high volume levels this clipping introduces gross amounts of 
distortion to the speaker, eventually destroying it. If the sound from your ceiling speakers starts to 
sound distorted, turn down the volume.
Having plenty of reserve power will help your speakers reproduce dynamic contrasts and quick 
transients of music much more effectively, but you do have to exercise good judgment; too much 
power will also permanently damage a speaker. Again, if you hear distortion, turn the volume down.
Specifi cations
Model number 
CS620C 
CS620CT 
CS820C 
CS820CT
Description  
8 ohm 
70V / 8 ohm 
8 ohm 
70V / 8 ohm
70V Taps  
NA 
0.62, 1.25, 2.5, 5, 10 W 
NA 
0.62, 1.25, 2.5, 5, 10 W
Woofer  
6.5" Poly cone 
6.5" Poly cone 
8" Poly cone 
8” Poly cone
Tweeter  
1" Mylar 
1" Mylar 
1" Mylar 
1” Mylar
Frequency response (Hz) 60-20,000 
60-20,000 
50-20,000  50-20,000
Dimensions H x W x D (in) 
8-1/2" dia x 2-3/4" D 
8-1/2" dia x 2-3/4" D 
10-3/4" dia x 3-5/8" D  10-3/4" dia x 3-5/8" D
Cut-out size H x W (in) 
7-3/8" dia. 
7-3/8" dia. 
9-1/8" dia. 
9-1/8” dia.
Power handling (RMS/Peak) 25/50 
25/50 
30/60 
30/60
SPL (1W/1m) 
88 dB 
88 dB 
89 dB 
89 dB
Ceiling Speaker
Dayton Audio
®
 
Last Revised:  1/8/2015
daytonaudio.com
tel + 937.743.8248
info@daytonaudio.com
705 Pleasant Valley Dr.
Springboro, OH 45066 
USA
Warranty Information
Dayton Audio products are constructed by industry experts, and are thoroughly tested before ship-
ment.  Dayton Audio products are warranted for the period of one year.  This warranty is limited to 
manufacturer defects, either in materials or workmanship.  Dayton Audio is not responsible for any 
consequential on inconsequential damage to any other unit or component or the cost for instal-
lation or extraction of any component of the audio system.  In the rare case of a product failure, 
please contact your place of purchase or call our Customer Support Department at (937) 743-8248.
Warranty Limitations
There are no other warranties, either express or implied, which extend the foregoing, and there are 
no warranties of merchantability or fi tness for any particular purpose.  The warranty will not cover  
incidental or consequential damage due to defective or improper use of products.  This includes but 
is not limited to burnt voice coils, overheating, bent frames, holes in the cone, or broken lead wires.
This warranty gives you specifi c legal rights and you may also have other rights which vary from 
state to state.
Non-Warranty Service:  If non-warranty service is required, the product may be sent to the Company 
for repair/replacement, transportation prepaid, by calling (937) 743-8248 for details, complete instruc-
tions, and service fee charges.
Models: CS620C/CS620CT
 CS820C/CS820CT
User Manual