Dynaudio SUB 600 用户手册
12
Dynaudio Sub 600
OPERATION
Connecting a single subwoofer
➊
To connect the SAT/SUB input:
From the preamplifier output of your processor/receiver, PC or mediaplayer (often
marked as Pre Out or Front Out) connect a stereo RCA cable to the subwoofer SAT/
SUB Input.
SUB Input.
This signal should not be already processed by the processor/receiver. Please pay
attention to the settings of your processor/receiver.
attention to the settings of your processor/receiver.
➋
To connect the LFE channel:
From the processor or receiver’s low-level (not a speaker output) subwoofer output
(often marked as “subwoofer out”, “Sub out” or “LFE”), connect a mono RCA-to-RCA
cable to the subwoofer input SUB I/O - LFE/Slave IN.
cable to the subwoofer input SUB I/O - LFE/Slave IN.
This signal should not be already processed by the processor/receiver. Please pay
attention to the settings of your processor/receiver.
attention to the settings of your processor/receiver.
Set the MODE switch to LFE.
Note:
You also can use both connection types. Both signals will be combined in the
Sub 600 and routed accordingly. This allows the Sub 600 to reproduce both the
LFE channel information as well as the bass range of the connected satellite
speakers
Sub 600 and routed accordingly. This allows the Sub 600 to reproduce both the
LFE channel information as well as the bass range of the connected satellite
speakers
ON
AUTO
GAIN
POWER
PHASE
SUB Lowpass
SAT Highpass
SAT/SUB Input
SAT Output
LFE / Slave IN
OUT
Flat 60 Hz
LFE
Slave
80 Hz
Min
Max
50 Hz
150 Hz
0° 180°
LEFT
RIGHT
SUB I/O
To Slave
➊ ➋
LFE/SUB Out
Front Out/
Pre Out
Pre Out