AudioSource 6.5" 2-Way I-Ceiling Dual Mono Speaker 用户手册

3

Tighten all four of the mounting screws in the same 
manner until the speaker is properly aligned and held 
tight to the wall surface. Caution: Do not over tighten!

A paint shield is included in each AS7c speaker 
package. Place the paint shield inside the frame to 
protect the speaker. You can now safely paint the 
speaker’s frame to match your wall surface if you desire.

When painting the grill caution should be taken to 
ensure that paint does not clog or congest the perforated 
openings in the grill. This would prevent proper operation 
of the grill by restricting the airflow from the individual 
drivers in the speaker.

The AS7c speaker is designed for use where the user 
desires to have sound available in an area but does not 
need stereo imaging. This may be because of limited 
space, such as a bathroom or dressing area, or a long 
hallway where even distribution of sound is desired but 
stereo imaging is impractical.

The AS7c uses a dual voice coil woofer and dual tweet-
ers. The speaker has separate terminals to allow each 
channel of a stereo amplifier to be connected to the one 
speaker.

The AS7c can also be operated by a single channel from 
an amplifier and used just like any conventional in-ceiling 
or in-wall speaker. In this configuration you should have 
both voice coils wired together in a parallel configuration.

Should it ever become necessary to remove the AS7c 
speaker from the ceiling, simply remove the grill and turn 
the four mounting screws counter-clockwise until you 
feel the doglegs lock out of position in their resting 
flange. The speaker should easily come out of the wall 
for service or replacement.

The resistance of the speaker wire in your installation 
can cause your speakers to perform at less than their 
optimum quality level. Excess resistance caused by 
using an undersized speaker wire can result in loss of 
detail and definition in the bass region of your audio 
program, as well as, a loss of dynamic range. Over 
extremely long wire runs you may even experience a 
loss of high frequency amplitude in the audio signal.

To prevent this effect in your installation we have 
recommended speaker wire gauges that should not 
exceed 0.5 ohms resistance over the recommended 
length of wire run.

For the AS7c speakers we suggest the following 
minimum speaker wire gauge be used:

50’ or less  -  16 Gauge 4-Cond. CL3
50’ - 150’    -  12 Gauge 4-Cond. CL3
150’ - 200’   -  10 Gauge 4-Cond. CL3 

6.5” T

wo W

ay 

Dual Mono In-Ceilling

100W / 8 ohm