Delphi RS-232 用户手册

 

4.3.1 

Gateway Commands 

The SAINT Gateway supports the following commands:  

08h 

80h 

None 

Perform Reset 

08h 

86h 

None 

Turn Time Stamp Information OFF 

08h 

87h 

None 

 Turn Time Stamp Information ON 

08h 

88h 

None 

Turn Transmit Echo ON  

08h 

89h 

None 

Turn Transmit Echo OFF  

08h 

92 

None 

Request Software Version 

08h 

F0h 

D1-D12 

Enable Gateway Trigger 

08h 

F1h 

None 

Disable Gateway Trigger 

4.3.1.1 

Reset 

This command will cause the gateway to do a complete cold start.  The gateway will ignore the next message. 

4.3.1.2 

Time Stamp  

This command controls whether a 16 bit time stamp is appended to the end of the bus message reports. 

4.3.1.3 

Transmit Echo 

This command controls whether transmitted messages are echoed back to the host when they are sent.  Echoed 
back messages will have their transmit bit set.  Currently the transmit echo is disabled. 

4.3.1.4 

Software Version Request 

This command requests the gateway software version (ASCII). 

4.3.1.5 

Trigger 

This command will cause the gateway to toggle the trigger LED upon receiving the specified byte pattern.  Up to 
12 data bytes may be used.  This feature is helpful for triggering an oscilloscope. (Not available with IDB firmware)