Multiquip HTN-27K-TCSL 用户手册

NEVER disable or disconnect the "safety stop switch". It is
provided for the operator's safety and injury or death may
result if it is disabled, disconnected or improperly
maintained.

1.

This 

ride-on trowel is equipped with a safety "safety stop

switch".  This switch is located beneath the seat assembly.
Remember the engine will not start unless an operator is
sitting in the operator’s seat. The weight of an operator
depresses an electrical switch which will allow the engine
to start.

6.

Keep your foot OFF the blade speed control pedal and in
all circumstances, start the engine at idle (without touching
the pedal).

7.

Insert the 

ignition key into the ignition switch.

8.

Turn the ignition key (Figure 10) clockwise and listen for
the engine to start. Once the engine starts release ignition
key.

9.

If the engine fails to start in this manner, consult the engine
owner's manual supplied with the trowel.

10. Test the safety stop switch by standing up briefly. The switch

under the seat should cause the engine to stop. If the  switch
fails to shut down the engine. Turn off the engine with the
key switch and repair the safety stop switch. See Table  7
(Troubleshooting ) for possible causes.

5. When starting a cold engine, pull the choke knob, if so

equipped, (Figure 9) out to the 

closed  position.  In warm

weather or when the engine is warm, the unit can be started
with choke halfway or completely 

open. (27 HP engine)

11. Let the engine idle for 3-5 minutes. If choke is applied,

push the choke to the open position as soon as the engine
will run smoothly.

3.

The right foot pedal (Figure 8) controls blade and engine
speed. The position of the foot pedal determines the blade
speed. Slow blade speed is obtained by slightly depressing
the pedal. Maximum blade speed is obtained by fully
depressing the pedal.

2.

The safety stop switch should be used to stop the engine
after every use. Doing this will verify the switch is working
properly thus providing  safety for the operator. Remember
to turn the key to the “OFF” position after stopping the
machine. Not doing so will drain the battery.

1.

With one foot on the ground and the other foot placed on
the trowel's platform, grab the frame near the seat and lift
yourself onto the trowel. Sit in the operator's seat and ensure
the control handles, foot pedal and control panel items can
be comfortably accessed.