Kingston Technology 6GB DDR3 240-pin DIMM Kit KHX2000C9AD3T1K3/6GX 数据表

6GB (2GB 256M x 64-Bit x 3 pcs.)
DDR3-2000 CL9 240-Pin DIMM Kit

Kingston's KHX2000C9AD3T1K3/6GX is a kit of three 256M x

64-bit (2GB) DDR3-2000 CL9 SDRAM (Synchronous DRAM),

1Rx8 memory modules, based on eight 256M x 8-bit  FBGA

components per module. Each module kit supports Intel

(Extreme Memory Profiles). Total kit capacity is 6GB. Each

module kit has been tested to run at DDR3-2000 at a low

latency timing of 9-10-9-27 at 1.65V. The SPDs are pro-

grammed to JEDEC standard latency DDR3-1333 timing of

9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers.

The JEDEC standard electrical and mechanical specifications

are as follows:

CL(IDD)

9 cycles

Row Cycle Time (tRCmin)

49.5ns (min.)

Refresh to Active/Refresh

160ns (min.)

Command Time (tRFCmin)

Row Active Time (tRASmin)

36ns (min.)

Power (Operating)

1.125 W* (per module)

UL Rating

94 V - 0

Operating Temperature

0

o

 C to 85

o

 C

Storage Temperature

-55

o

 C to +100

o

 C

*Power will vary depending on the SDRAM used.

•

JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply

•

VDDQ = 1.5V (1.425V ~ 1.575V)

•

667MHz fCK for 1333Mb/sec/pin

•

8 independent internal bank

•

Programmable CAS Latency: 9, 8, 7, 6

•

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

•

Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)

•

8-bit pre-fetch

•

Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]

•

Bi-directional Differential Data Strobe

•

Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)

•

On Die Termination using ODT pin

•

Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C

•

Asynchronous Reset

•

PCB : Height 2.401” (61.00mm) w/ heatsink, single  sided
component

Memory Module Specifi cations

Continued >>

Keyed

Keyed

•

JEDEC: DDR3-1333 CL9-9-9 @1.5V

•

XMP Profile #1: D3-2000 CL9-10-9-27 @1.65V

•

XMP Profile #2: D3-1866 CL9-10-9-27 @1.65V