Kenwood TK-360 用户手册

6

Press   to switch the transceiver ON.

•  A beep sounds and the display illuminates.  If the Power-on tone select is set to OFF, 

the beep will not sound.

•  If the Transceiver Password function is programmed, “PASSWORD” will appear on the 

display.  Refer to “Transceiver Password”, on page 6.

Press   again to switch the transceiver OFF.

n

  To enter the password:

  Press  /  to select a digit.

•  When using a keypad, simply enter the password digits and proceed to step 4.

  Press C> to accept the entered digit and move to the next digit.

•  Press A or # to delete an incorrect digit.  Press and hold A or # to delete all 

digits.

  Repeat steps  and 2 to enter the entire password.

  Press S or   to confirm the password.

•  If you enter an incorrect password, the transceiver remains locked.

Press the Volume Up key to increase the volume.  Press the Volume Down key 

to decrease the volume.
If Squelch Off has been programmed onto a key, you can use that function to 

listen to background noise while adjusting the volume level.

Select the desired zone and channel/group ID using the keys programmed as 

/ Zone Down and CH/GID Up/ CH/GID Down.

•  You can program names for zones and channels/group IDs with up to 0 

characters.

n

  You can select your Home channel/group ID by pressing Home CH/GID.  

Press the key a second time to return to your previous channel/group ID.

n

  You can quickly select a commonly used channel/group ID by pressing Direct 

 ~ Direct CH/GID 4.  Press the same key a second time to return to 

your previous channel/group ID (if the key assignment Direct CH/GID return is 

configured as “Enabled”).