Kompernass KH 2375 重要安全性说明

下载
页码 74
- 11 -
Settings for the multi controller
Via the multi controller you can, in addition, admi-
nister settings for the switch on volume, time of day
settings, traffic radio volume, EON function, recor-
ding format and the equalizer.
• Hold down the multi controller for approx. 2 se-
conds and then press it several times to access
the following settings:
INVOL - switch on volume
• Turn the multi controller in order to set a volume
level, which will apply when the car radio is 
switched on. 
ADJ - Time of day 
Your car radio is equipped with an RDS controlled
clock. The clock sets itself automatically when the
EON function is switched on and also continues to
run when the radio is switched off. If you do not 
receive any RDS signal you can also set the time of
day manually.
• Turn the multi controller to the right to set the
hours and to the left to set the minutes.
TAVOL - Volume for traffic radio
• Turn the multi controller in order to set a volume
level, which will apply when the traffic report is
switched on.
EON - Function
Turn the multi controller in order to switch the EON
function on (EON ON) or off (EON OFF). When
the EON function is switched on the radio switches
to traffic radio or PTY types if the TA or PTY function
has been switched on.
REC - Recording format
• Turn the multi controller to set the record format
for recording on SD/MMC and/or USB data
carriers, MP3 (MP3 data) or WMA (Windows
Media Audio).
DSP - Equalizer 
• Turn the multi controller to select one of the set-
tings DSP CLASSIC, DSP ROCK, DSP POP, DSP
FLAT or DSP NONE. In the setting DSP NONE
no Digital Sound Processing (DSP) is switched on.
You can also set the equalizer by pressing the DSP
button on the remote control. With this setting DSP is
switched off when the radio frequency is shown
again.
The DSP equalizer setting is shown at the bottom of
the display.
Radio functions
Selecting the band range
• Press the BND/ENT button to switch between USW
(FM1, FM2, FM3) and medium wave (MW1,
MW2).
Automatic station search
• Press briefly the search buttons 
 or  to start
a search forwards/backwards. The search stops
at the next station found.
Manual station selection
• When you hold down one of the buttons 
 or
 for two seconds you switch to manual station
search.  MANUAL appears in the display.
• Now press the search buttons 
 or  several 
times to set the frequency in steps of 0.05 MHz
(MW: 9 kHz) up/down.
If no button is pressed for approx. two seconds the
automatic station search is set again.  AUTO appears
in the display..
IB_KH2375_VY3995_LB3A  23.04.2008  10:51 Uhr  Seite 11