JL Audio 94451 用户手册
Continued on Next Page
SB-F-FLX-10W3v3 INSTR_SKU# 011293
s t e P 7
Using a Die grinder (or a Dremel® type tool), grind off all of
the plastic welds as shown.
Using a Die grinder (or a Dremel® type tool), grind off all of
the plastic welds as shown.
***CautIon***
always follow proper safety techniques when using
power tools as described by the tool manufacturer.
power tools as described by the tool manufacturer.
s t e P 6
The factory subwoofer grille (as shown) needs to be
removed, this process will be completed namely from the
back side of the panel.
The factory subwoofer grille (as shown) needs to be
removed, this process will be completed namely from the
back side of the panel.
s t e P 5
Remove the OEM subwoofer/amplifier as shown. Run the
wire for the Stealthbox® to this general location (indicated by
arrow) as the Stealthbox® will be mounted here, leave extra
wire so that you can secure it as desired once the installation
is finished.
Remove the OEM subwoofer/amplifier as shown. Run the
wire for the Stealthbox® to this general location (indicated by
arrow) as the Stealthbox® will be mounted here, leave extra
wire so that you can secure it as desired once the installation
is finished.
s t e P 4
Remove the interior plastic trim panel, you can leave the
sections of the panel that the seatbelts go through as
shown.
Remove the interior plastic trim panel, you can leave the
sections of the panel that the seatbelts go through as
shown.
Page 2 • JL Audio, Inc 2009
S T E P 9
Looking at the panel from the front, trim all of the edges
of the opening so that on the sides and bottom, there is a
flange inside the recess where the grille was that is 1” wide
and at the top, the flange should be approximately 3/8” wide
as shown.
Looking at the panel from the front, trim all of the edges
of the opening so that on the sides and bottom, there is a
flange inside the recess where the grille was that is 1” wide
and at the top, the flange should be approximately 3/8” wide
as shown.
S T E P 1 1
Remove the woofer and, stuffing from the Stealthbox, slide
the Stealthbox® into position, mark the two mounting holes
as shown, remove the enclosure.
Remove the woofer and, stuffing from the Stealthbox, slide
the Stealthbox® into position, mark the two mounting holes
as shown, remove the enclosure.
S T E P 1 0
Re-install the interior panel along with all of the previously
removed panels. Make sure that you can access the previ-
ously run wire for the Stealthbox®.
Re-install the interior panel along with all of the previously
removed panels. Make sure that you can access the previ-
ously run wire for the Stealthbox®.
S T E P 8
This is the back of the grille completely removed showing all
of the welds that needed to be removed.
This is the back of the grille completely removed showing all
of the welds that needed to be removed.
3/8”
1”