Phoenix Gold TI600.4 用户手册

© 2010 Phoenix Gold • www.phoenixgold.com  

Connect preamp signal cables from the head unit to these terminals.

Provides a full range signal for an additional amplifier. There is no signal
loss if using this output.

Controls the lowpass crossover point for the speaker outputs.

Variable bass boost from 0 to +18dB @ 45 Hz.

This port is for connecting the optional remote level control (LPL44). This
allows up to 20dB of volume adjustment. This is not a bass boost, it
controls the level of the low pass signal.

Connect optional RMD Voltage Display to this port

Used to reach maximum amplifier power with a wide variety of headunits.

Controls the highpass crossover point for the speaker outputs to eliminate extreme
low frequencies.

Lights when the amplifier reaches near maximum output. Under normal
operation the peak indicator should be flashing during the peaks of the
music. Peak indicator should not stay lit for long periods of time (more
than 2 or 3 seconds), if this is the case you need to reduce system volume
or level of the amplifier.

Lights red if there is a problem with the audio system. For example, speaker wire is
pinched/shorted together or the amplifier is running too low of an impedance.

This must be connected to the fused positive terminal (+12V) of the car’s
battery. The fuse must be located within 18 inches of the battery.

This must be connected to switched +12V, usually a trigger wire coming
from the head unit or ignition.

 

This must be connected to the negative terminal of the car’s battery or
bolted to a clean, unpainted part of the chassis of the vehicle.

Used to connect the amplifier to speakers. Minimum impedance is 1 ohm.

phoenix gold ti amp manual.indd   3

3/2/10   11:20:40 AM