ONKYO TX-SR602E 操作指南

下载
页码 96
 
13
 
Remote Controller
 
Notes:
 
• The batteries should last for about six months, 
although this will vary with usage.
• If the remote controller doesn’t work reliably, try 
replacing the batteries.
• Don’t mix new and old batteries or different types of 
batteries.
• If you intend not to use the remote controller for a long 
time, remove the batteries to prevent damage from 
leakage or corrosion.
• Expired batteries should be removed as soon as possi-
ble to prevent damage from leakage or corrosion.
To use the remote controller, point it at the AV receiver’s 
remote control sensor, as shown below.
 
Notes:
 
• The remote controller may not work reliably if the AV 
receiver is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in 
mind when installing.
• If another remote controller of the same type is used in 
the same room, or the AV receiver is installed close to 
equipment that uses infrared rays, the remote control-
ler may not work reliably.
• Don’t put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller may not work reliably if the AV 
receiver is installed in a rack behind colored glass 
doors. Keep this in mind when installing.
• The remote controller will not work if there’s an obsta-
cle between it and the AV receiver’s remote control 
sensor.
 
Installing the Batteries
 
1
 
To open the battery compartment, press 
the small hollow and slide off the cover.
 
2
 
Insert the three supplied batteries (AA/R6) 
in accordance with the polarity diagram 
inside the battery compartment.
 
3
 
Put the cover onto the remote controller 
and slide it shut.
 
Using the Remote Controller
30˚
30˚
Appro
x.
 16 ft.
 
(5 m)
Remote control sensor
TX-NR702,602_En.book Page 13 Tuesday, September 7, 2004 1:18 PM