ONKYO CR-545 CR-545UKD 用户手册
Troubleshooting—Continued
50
Clock
The time is not displayed in Standby mode.
• The clock is not displayed in Standby mode. Press CLOCK CALL, the clock display appears for eight
• The clock is not displayed in Standby mode. Press CLOCK CALL, the clock display appears for eight
seconds.
• If there is a power failure, the clock will stop and “Adjust” will appear when the clock is displayed with the
CLOCK CALL button. Set the clock in this case. If AccuClock is enabled, the clock will be set
automatically.
automatically.
Others
“RESET” appears after the power cord is connected.
• Because the power cord was disconnected for a long time, the memory contents have been reset and all
• Because the power cord was disconnected for a long time, the memory contents have been reset and all
settings returned to the factory default settings. Perform the required settings again.
The power turns on when the power cord is connected to a power outlet.
• If the power cord is disconnected while the power is ON, the power will turn ON the next time the power
• If the power cord is disconnected while the power is ON, the power will turn ON the next time the power
cord is connected. If there is a power failure while the power is ON, disconnect the power cord.
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the
unit’s malfunction. Before you record important data, make sure that the material will be recorded correctly.
The CD receiver contains a microcomputer for control functions. In very rare situations, severe interference,
noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this should
happen, unplug the power cord, wait at least 5 seconds, and then plug it again.
If it’s not cleared, please refer to “How to reset to factory default?” on page 47
.