ONKYO CR-545 CR-545UKD 用户手册

下载
页码 52
Before Using the CD Receiver 
Installing the Batteries 
Open the battery compartment, as 
shown. 
 
Insert two batteries (R6 / AA) into the 
battery compartment. 
Carefully follow the polarity diagram 
(positive (+) and negative (–) symbols) 
inside the battery compartment. 
 
After the batteries are installed and 
seated correctly, attach the 
compartment cover. 
 
 
Notes: 
•    If the remote controller doesn’t work reliably, try 
replacing the batteries. 
•    Don’t mix new and old batteries or different 
types of batteries. 
•    If you intend not to use the remote controller for 
a long time, remove the batteries to prevent 
damage from leakage or corrosion. 
•    Expired batteries should be removed as soon as 
possible to prevent damage from leakage or 
corrosion. 
 
 
Using the Remote Controller 
When you operate the remote controller, point it at 
the CD receiver’s remote control sensor. 
 
 
 
 
 
Notes: 
•    The remote controller may not work reliably if 
the CD receiver is subjected to bright light, such 
as direct sunlight or inverter-type fluorescent 
lights. Keep this in mind when installing. 
•    If another remote controller of the same type is 
used in the same room, or the CD receiver is 
installed close to equipment that uses infrared 
rays, the remote controller may not work reliably. 
•    Don’t put anything, such as a book, on the 
remote controller because the buttons may be 
pressed inadvertently, thereby draining the 
batteries. 
•    The remote controller may not work reliably if 
the CD receiver is installed in a rack behind 
colored glass doors. Keep this in mind when 
installing. 
•    The remote controller will not work if there’s an 
obstacle between it and the CD receiver’s remote 
control sensor. 
 
 
Ap
prox
. 5
 m
 
(16
 ft.
)
Remote control sensor