ONKYO TX-SR702E 操作指南

 

36

 

The AV receiver’s PHONO IN is designed for use with a 
moving magnet (MM) type cartridge. 
Use an analog audio cable to connect the AV receiver’s 
PHONO IN L/R jacks to the audio output on your turn-
table, as shown.

 

• If your turntable has a ground wire, connect it to the 

AV receiver’s GND screw. With some turntables, con-
necting the ground wire may produce an audible hum. 
If this happens, disconnected it.

• If your turntable has a moving coil (MC) type car-

tridge, you’ll need a commercially available MC head 
amp or MC transformer. Connect your turntable to the 
head amp or transformer, and then connect that to the 
AV receiver’s PHONO IN L/R jacks.

• You can also use a phono equalizer to connect a turn-

table with an MC-type cartridge. In this case, see the 
phono equalizer’s manual for details.

 

■

 

Use an analog audio cable to connect an unused audio 
input on the AV receiver to the audio outputs on your 
turntable, as shown.

 

■

 

Use an analog audio cable to connect an unused audio 
input on the AV receiver to the audio outputs on your 
phono preamp, and use another analog audio cable to 
connect the phono preamp’s inputs to your turntable, as 
shown.

 

■

 

Use an analog audio cable to connect an unused audio 
input on the AV receiver to the audio outputs on your 
phono preamp. Use another analog audio cable to con-
nect the phono preamp’s inputs to your MC head amp’s 
outputs. And use another analog audio cable to connect 
the MC head amp’s inputs to your turntable, as shown.

TX-NR702,602_En.book Page 36 Tuesday, September 7, 2004 1:18 PM