Faber M1600 用户手册

Operational Reference  •  67 

On power up the Genie camera initializes to a factory default state which sets the camera with neutral parameters 
and in free run mode. The default state ensures that the camera is ready for acquisition. Genie also provides storage 
for one user-defined state. This user state allows quick camera configuration for a known repeatable imaging 
system. The following table describes the camera parameters stored in the user state. See 

on page 32

 for information on saving the user state with CamExpert. 

 

ROI  

Region of interest used to crop the image 

Pixel Format 

Defines the pixel format (MONO8) 

Frame Rate  

Defines the frame rate for free run mode.  

Exposure mode 

Defines the exposure mode (Programmable or Pulse Controlled) 

Exposure duration 

Defines the exposure duration for Programmable mode 

Exposure synchronization 

Synchronous or Reset synchronization mode 

Gain 

Defines the sensor analog Gain factor.  

Black Level 

Defines the sensor analog Black level factor.  

Binning 

Horizontal and vertical binning factor 

Flip 

Horizontal flip: Off or On 

Image source 

Defines the image source as the sensor or one of the stored image patterns.  

Trigger enable 

Free-running or triggered 

Trigger source 

Selects the trigger input (input pin or software) 

Trigger delay 

Defines the delay from input trigger to exposure start.  

GPI settings 

Defines the operational mode of the general input pins.  

GPO settings 

Defines the operational mode of the general output pins 

LUT 

Lookup Table function On or Off plus the LUT data.  

Flat Field Correction 

FFC function On or Off plus the offset/gain data.