Canon VB101 用户手册
160
Using the Enclosed Software
Use the "IniVB101.exe" and "inivb101.elf" files in the same directory on the enclosed CD-ROM to
restore the VB101 settings to the factory default values.
2
1
Connect the VB101 to your PC (
→ P.33), insert the enclosed CD-ROM
into the CD-ROM drive and launch the "IniVB101.exe" program.
When the "IniVB101.exe" dialog box appears, perform steps
to
below to restore the factory default settings.
Switch the VB101 off and then
on again.
Select direct connection to COM1 as the connection method.
Enter the password (the default setting is "VB101").
● When you switch the VB101 on again,
the [Next] button is enabled.
● On some PCs you may have to select a port other than COM1.
Check the port number to which the serial cable is connected.
When the confirmation message
appears, click the [OK] button.
●The factory default setting are
restored
restored
1
2
3
4
c
Note
● When you click the [Cancel] button after switching the VB101 back on, the
power LED remains lit orange. At this point, the VB101 software has not
started up. If you do not need to change the settings, switch the VB101 to
off and then on again and check that the power LED is green. To begin the
setup procedure again, launch "IniVB101.exe" and then switch the VB101
off and on again as directed by the on-screen instructions.
● If you forget the password, you will have to return the VB101 to a service
center. Please contact your Canon dealer.
● Refer to P.162 for the factory default settings.
Restoring the Factory Default Settings