Plasmon LF 8600 用户手册
97663032 A
Page 69
SETTING THE WRITE PROTECT OPTION
The write protect option enables the user to inhibit the LF 8600 from writing to any media inserted into the
drive, regardless of the write protect setting on the media cartridges.
drive, regardless of the write protect setting on the media cartridges.
Perform the following procedure to turn write protect on or off:
1. Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2. Press the MENU switch until "Set Config" is displayed.
3. Press the SELECT switch to enter the Set Configuration menu.
4. Press the MENU switch until "Wrt Prot:" is displayed.
5. Press the SELECT switch to scroll through the states for write protect (off, on). When the
desired state is displayed, press MENU to enter the state and move to the next option in the
Set Configuration menu.
Set Configuration menu.
6. Simultaneously press the LOAD/MENU and TEST/SELECT switches to move up to the Main
menu. Simultaneously press the LOAD/MENU and TEST/SELECT switches again to exit
Configuration mode.
Configuration mode.
NOTE
The Write Protect indicator on the DOC is illuminated when write
protect is enabled.
protect is enabled.
SETTING THE MEDIA AUTOLOAD OPTION
The media AutoLoad load option enables a user to choose which media cartridge is automatically inserted
and loaded at power up and whenever the LOAD/MENU switch is pressed while in the Operating mode.
The factory default selects the cartridge in slot 1. The options are 1 - 6 or Most Recently Used (MRU).
and loaded at power up and whenever the LOAD/MENU switch is pressed while in the Operating mode.
The factory default selects the cartridge in slot 1. The options are 1 - 6 or Most Recently Used (MRU).
Perform the following procedure to set the LF 8600's AutoSpin option:
1. Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2. Press the MENU switch until "Set Config" is displayed.
3. Press the SELECT switch to enter the Set Configuration menu.
4. Press the MENU switch until "AutoLoad:" is displayed.
5. Press the SELECT switch to scroll through the Auto Load options. The drive can be
configured to load the cartridge residing in a specific slot 0 - 6 or the Most Recently Used
(MRU) cartridge. When the desired option is displayed, press the MENU switch to enable
that option and select the next option in the Set Configuration menu.
(MRU) cartridge. When the desired option is displayed, press the MENU switch to enable
that option and select the next option in the Set Configuration menu.
6. Simultaneously press the LOAD/MENU and TEST/SELECT switches to move up to the Main
menu. Simultaneously press the LOAD/MENU and TEST/SELECT switches again to exit
Configuration mode.
Configuration mode.