GE 513 用户手册
Operating Instructions
Safety Instructions
Customer Service
Troubleshooting T
ips
Before you call for service…
Problem
Possible Causes
What To Do
Dryer doesn’t start
Dryer is unplugged
• Make sure the dryer plug is pushed completely into
the outlet.
Fuse is blown/circuit breaker is
• Check the house fuse/circuit breaker box and
tripped
replace fuse or reset breaker. NOTE: Most electric
dryers use two fuses/breakers.
dryers use two fuses/breakers.
Dryer doesn’t heat
Fuse is blown/circuit breaker is
• Check the house fuse/circuit breaker box and
tripped, the dryer may tumble
replace fuse or reset breaker.
but not heat
Gas service is off
• Make sure gas shutoff at dryer and main shutoff are
fully open.
Dryer shakes or makes
Some shaking/noise is normal.
• Move dryer to an even floor space, or adjust
noise
Dryer may be sitting unevenly
leveling legs as necessary until even.
Greasy spots on clothes
Improper use of fabric softener
• Follow directions on fabric softener package.
Drying dirty items with clean ones •
Use your dryer to dry only clean items. Dirty items can
stain clean items and the dryer.
stain clean items and the dryer.
Clothes were not completely clean •
Sometimes stains which cannot be seen when the
clothes are wet appear after drying. Use proper
washing procedures before drying.
clothes are wet appear after drying. Use proper
washing procedures before drying.
Lint on clothes
Lint filter is full
• Clean lint screen before each load.
Improper sorting
• Sort lint producers (like chenille) from lint collectors
(like corduroy).
Static electricity can attract lint
• See suggestions in this section under STATIC.
Overloading
• Separate large loads into smaller ones.
Paper, tissue, etc., left in pockets
• Empty all pockets before laundering clothes.
Static occurs
No fabric softener was used
• Try a fabric softener.
• Bounce® Fabric Conditioner Dryer Sheets have
been approved for use in all GE Dryers when used in
accordance with the manufacturer’s instructions.
accordance with the manufacturer’s instructions.
Overdrying
• Try a fabric softener.
• Adjust controls for less drying.
Synthetics, permanent press and •
Try a fabric softener.
blends can cause static
Inconsistent drying times
Type of heat
• Automatic drying times will vary according to the type
of heat used (electric, natural or LP gas), size of load,
types of fabrics, wetness of clothes and condition of
exhaust ducts.
types of fabrics, wetness of clothes and condition of
exhaust ducts.
Troubleshooting Tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
12