Ryobi P514 用户手册

8 – English

Always remove battery pack from your tool when you are 
assembling parts, making adjustments, cleaning, or when 
not in use. Removing battery pack will prevent accidental 
starting that could cause serious personal injury.

See Figure 2, page 11.


  Depress the latches on each side of the battery pack.



  Remove the battery pack from the tool.

Battery products are always in operating condition. 
Therefore, the switch should always be locked when not 
in use or carrying at your side.

See Figure 3, page 11.


  Remove the battery pack.



  Lift the blade clamp lock/release lever located on the side 

of saw.



  Insert the saw blade between the blade clamp and the 

saw bar.



  Lower the blade clamp lever to lock.



  Replace the battery pack.

See Figure 4, page 12.
The shoe assembly of the reciprocating saw pivots up and 
down in both directions. It is adjustable, allowing the use of 
the blade teeth at different positions on the blade.
To change positions of shoe assembly:


  Remove battery pack.



  Loosen the set screw near the shoe assembly with the 

hex key provided with this saw.



  Reposition shoe assembly to desired position.



  Retighten set screw securely. Do not overtighten screw 

or use an aid with the hex key.



  Remove hex key and store for later use.



  Replace the battery pack.

Make sure blade does not touch work until motor reaches 
full speed, since this could cause loss of control resulting 
in serious injury.

Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is 
sufficient to inflict serious injury.

Always wear eye protection with side shields marked to 
comply with ANSI Z87.1. Failure to do so could result in 
objects being thrown into your eyes resulting in possible 
serious injury.

Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of 
attachments or accessories not recommended can result 
in serious personal injury.

You may use this product for the purposes listed below:


Cutting all types of wood products (lumber, plywood, 
paneling, composition board, and hard wood)



Cutting masonite and plastic



Cutting drywall



Cutting metals such as sheet steel, pipe, steel rods, 
aluminum, brass, and copper

This product will accept Ryobi One+ 18 V lithium-ion battery 
packs and Ryobi One+ 18 V nickel-cadmium battery packs.
For complete charging instructions, refer to the Operator’s 
Manual for the battery packs and chargers for your models.

Ryobi lithium-ion batteries are designed with features that 
protect the lithium-ion cells and maximize battery life. 
If the tool stops during use, release the trigger to reset and 
resume operation. If the tool still does not work, the battery 
needs to be recharged.

See Figure 2, page 11.


  Insert the battery pack into the product as shown.



  Make sure the latches on each side of the battery pack 

snap into place and the battery pack is secured before 
beginning operation.