Husqvarna 50 用户手册

The ProEdge Line of beveled diamond blades is especially designed for architectural scoring to replace labor-intensive hand 

tooling. These specialty blades are ideal for residential and commercial applications to chase standard joints for a beveled look. 

Chasing cuts using the ProEdge blades would begin the next day or later after the concrete is placed and control joints have 

been made. Choose the correct specification of ProEdge blade to suit your particular needs

 

 

ProEdge V-Blade  

XL5-V21-X50     3/8” (9.53mm) wide bevel blade for existing 0.100” (2.54mm) wide saw cut

 

 

 

 

XL5-V23-X50     5/8” (15.88mm) wide bevel blade for existing 0.100” (2.54mm) wide saw cut

 

 

 

 

XL5-V25-X50     5/8” (15.88mm) wide bevel blade for existing 0.250” (6.35mm) wide saw cut

 

 

 

 

 

ProEdge Radius Blade 

XL5-R250-X50   5/8” (15.88mm) wide bevel blade for existing 0.100” (2.54mm) wide saw cut

 

 

 

 

XL6-R500-X50   3/4” (19.1mm) wide bevel blade for existing 0.100” (2.54mm) wide saw cut 

Choose the correct specification of ProEdge Blade based on the width of the pre-existing control joint as follow:

Follow the instructions for installing a Excel series blade and 

skid plate when installing a ProEdge blade.
NOTE:  

Adjust bevel depth of cut by loosening the depth adjust arm. 

Pull up on the lower guard until the proper amount of blade 

protrudes below the skid plate. (See figure below for proper 

depth).

Line up the saw by pushing down on the saw lower the blade 

into the existing cut. Use the “V” notch on the front of the 

lower guard to fine tune alignment. Flip the lock-off button and 

squeeze the paddle switch to turn “ON” the saw. Allow the 

blade to reach maximum speed the rotate the saw down to 

plunge the blade into the concrete until the depth adjust arm 

bottoms down against the depth stop bolt.
Step 4

Push the saw forward to cut, keeping the guide wheel on the 

cut line. Maintain an even cutting speed for best results.

Set the depth adjust arm firmly against the depth stop bolt and 

tighten the depth adjust thumb screw to set the depth. Remove 

the guide wheel and reinstall with the shoulder against the 

guide arm (See illustration: Guide wheel installation).